=====================  Product Identification  =====================

Product ID:ACRY-PLEX FLAT WALL ENAMEL, 555-SERIES (ALL COLORS)
MSDS Date:09/20/1994
FSC:8010
NIIN:00N081608
=== Responsible Party ===
Company Name:KELLY-MOORE PAINT CO INC
Address:1015 COMMERCIAL ST
City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Info Phone Num:415-592-8337
Emergency Phone Num:800-424-9300 (CHEMTREC)
Preparer's Name:JULIAN SHAFFER
CAGE:0Y837
=== Contractor Identification ===
Company Name:KELLY-MOORE PAINT CO INC
Address:987 COMMERCIAL ST
Box:City:SAN CARLOS
State:CA
ZIP:94070
Country:US
Phone:650-592-8337
CAGE:0Y837

=============  Composition/Information on Ingredients  =============

Ingred Name:PROPIONIC ACID, 2-METHYL-, MONOESTER WITH
    2,2,4-TRIMETHYL-1,3-PENTANEDIOL; (TEXANOL)
CAS:25265-77-4
RTECS #:UF6000000
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:SILICATES; (MINERAL SILICATES)
OSHA PEL:10 MG/M3
ACGIH TLV:10 MG/M3

Ingred Name:CALCIUM CARBONATE (MARBLE) (LIMESTONE)
CAS:1317-65-3
RTECS #:EV9580000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9495

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9495

Ingred Name:SILICA, CRYSTALLINE - QUARTZ
CAS:14808-60-7
RTECS #:VV7330000
Fraction by Wt: TRACE
OSHA PEL:SEE TABLE Z-3
ACGIH TLV:0.1 MG/M3 RDUST;9495

Ingred Name:4-ISOTHIAZOLIN-3-ONE, 5-CHLORO-2-METHYL-; (PAINT
    PRESERVATIVE)
CAS:26172-55-4
RTECS #:NX8156850
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: DIZZINESS, HEADACHE, NAUSEA,
    CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, UNCONSCIOUSNESS,
    SKIN AND EYE IRRITATION. CHRONIC: NONE KNOWN.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARD.
Medical Cond Aggravated by Exposure:NONE KNOWN. SEE YOUR PHYSICIAN FOR
    SPECIFIC MEDICAL OPINION REGARDING YOUR CONDITION.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT
    PHYSICIAN. EYE CONTACT: FLUSH WITH LARGE VOLUMES OF WATER FOR AT
    LEAST 15 MINUTES. GET MEDICAL ATTENTION. SKIN CONTACT: WIPE OFF
    WITH A RAG.  WASH THOROUGHLY WITH SOAP AND WATER. INGESTION:
    CONSULT HOSPITAL EMERGENCY ROOM OR POISON CONTROL CENTER
    IMMEDIATELY.

=====================  Fire Fighting Measures  =====================

Flash Point:NONE
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO THE
    BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS.
    FOR SMALL SPILLS, SOAK UP WITH ABSORBANT. FOR LARGER SPILLS, DIKE
    AREA WITH ABSORBENT MATERIAL AND SCOOP UP LIQUIDS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
    AWAY FROM HEAT AND FLAME.
Other Precautions:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE A PARTICLE MASK (NIOSH TC-21C) TO AVOID
    BRTHG SPRAY MIST/SANDING DUST IF LOCAL VENT IS ADEQ TO KEEP VAP
    CONC W/IN ACCEPTABLE (TVL) LIMS. IF LOCAL VENT IS NOT
    SUFFICIENT/WHERE EXPOS LIMS ARE EXCEED ED. WEAR A SUITABLE (SUPDAT)
Ventilation:LOCAL CROSS-VENT OR MECHANICAL EXHAUST SUFFICIENT TO KEEP
    ALL HAZARDOUS VAPOR CONCENTRATIONS BELOW PRESCRIBED LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
    ANSI DESIGN CRITERIA .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
RESP PROT: PROPERLY FITTED RESPIRATOR (NIOSH TC-23C OR BETTER) FOR
    ORGANIC VAPORS WITH A DUST FILTER AS NEEDED.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:212F,100C
Vapor Density:LTR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:60-65

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NOT APPLICABLE.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
    HEATED TO DECOMPOSITION AS IN WELDING.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISCARD IN LANDFILL IN SEALED METAL CONTAINERS
    AWAY FROM HEAT AND FLAME AND IN ACCORDANCE WITH FEDERAL, STATE AND
    LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.